9702 Instructions 10-7-13.doc Page 1 of 1
9002-9702 Installation Instructions (Infinity Auto Dimming
Wedge Mount Mirror with HomeLink)
IMPORTANT: Check kit contents and read instructions before installing. For the latest full color instructions please visit
www.brandmotion.com
Kit Contents
Infinity Auto Dimming Mirror with HomeLink Mirror Harness
Homelink Programming and Information Guide These Instructions
Mirror Mounting
NOTE: This mirror has a Wedge/ D-tab style mounting base; please check our Application Guide to ensure it is compatible with your
vehicle. Additionally, Brandmotion offers windshield mirror adapter brackets, Kit # 5000-VWAB (some Volkswagen vehicles) and Kit
#5000-CAMLOCK (some Honda & Subaru vehicles), available separately.
NOTE 2: In some cases, it may be necessary to remove a cover to access the wedge mount on the windshield and/or modify the
cover slightly to clear the mirror mount. Additionally, if your vehicle is equipped with a mirror cover, mirror adjustability may be
restricted.
To install:
1. Loosen vehicle mirror screw using a T20 Torx driver and remove
existing vehicle mirror.
CAUTION: Do not twist mirror as windshield damage could result.
2. Carefully slide supplied Mirror onto windshield tab.
3. Torque supplied Mirror screw to 1.8 Nm (16 lb-in) and do not exceed
2.2 Nm (19.5 lb-in).
Mirror Wiring
1. Use a multimeter to test for vehicle Igniton (+) and Reverse (+)
signals. Typical locations are behind the driver or passenger side kick
panel or under the dash. Set parking brake, start vehicle, and have
an assistant shift into Reverse while you test for Ignition and
Reverse signals.
2. Plug Mirror Harness into Mirror and route beneath
headliner and down the A-pillar closest to the
Ignition and Reverse signal locations.
3. Splice Mirror Harness wires to the following required
connections:
Red - Ignition controlled power 12v+ when key is
ON
Black - Chassis ground
Green - Connect to Reverse (+) 12V power.
NOTE: While not a required connection, connecting Reverse
disables the vehicle’s auto dim function while vehicle is in reverse.
4. If vehicle is equipped with Exterior Auto Dimming
Mirrors, use a multimeter to identify the appropriate
vehicle wires and splice the Blue wire to Exterior
EC (auto dimming) mirrors (–) and the White wire
to Exterior EC (auto dimming) mirrors (+)
IMPORTANT: If vehicle is NOT equipped with Exterior Auto
Dimming Mirrors, isolate Blue & White wires and cover
with electrical tape.
HomeLink Set Up and Operation
1. Refer to supplied HomeLink “Programming and
Information Guide.”
2. Keep HomeLink “Programming and Information Guide” in vehicle for future reference.
This HomeLink device is approved for use only in the United States and Canada.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals