9650 Instructions 2-11-14.doc Page 2 of 2
Camera Requirements
The camera signal must be strong enough for the mirror to detect signal when reverse is engaged. We recommend
that the camera be connected to mirror prior to installation to confirm compatiblity. Best results are on cameras that
have a 0.8- 1.6v DC coming out of video composite lead (commonly a yellow RCA jack). Depending on camera output it
may require reverse to be supplied by a 12v switched ignition rather than reverse feed. To test this use a multimeter set
to DC and connect the (-) lead to the camera RCA shield and the (+) lead to the camera RCA tip with the camera
powered ON.
Powering Up the Camera
The mirror stays ON for over 1 second when reverse is disengaged, and if the camera is connected to the reverse
tail lamp then the screen will flash Blue. If the camera does not power up instantly when the vehicle is shifted into
reverse, the screen will not detect the camera and will not display an image. For these reasons we recommend that the
camera be connected to Ignition (+).
Test Mirror
Set parking brake, start vehicle, and shift into Reverse. If image appears in the LCD display, all connections have
been made properly.
Temporary Monitor Manual Shut Down:
If while in reverse you require to turn OFF the camera monitor, simply press and release the POWER button on the
back side of the mirror. (Note: once reverse is disengaged the mirror will go back to normal operation and will turn
ON next time reverse is engaged).
NOTE 1: Mirror Voltage Requirements
The supplied Mirror must see a voltage of 12.5v DC or better on the Reverse trigger lead. In the event that the
signal is too low the signal quality may be affected drastically when the vehicle is running.
To correct low Reverse signal power, the voltage must be raised using a Single Pull Dual Throw Relay.
Relay Wiring:
30 To mirror Reverse trigger (Green lead)
85 Chassis Ground
86 Reverse trigger from vehicle (reverse lamp)
87 High current Ignition controlled power lead +
87a Not used
Connect the rest of the Mirror Harness wires as instructed above.
NOTE 2: For Ford vehicles only
If the vehicle has a separate display on the IP for the compass and it displays “– –“after the OE mirror is removed,
further steps are necessary in order for it to function again. You must supply two 9’ 20-gauge wires (recommended:
one red and one yellow). Splice the wires to the location from which you removed the vehicle’s mirror connector and
splice their opposite ends to the vehicle’s mirror connector that will be relocated along with the mirror circuit board.
For more details, refer to Section 6 of 1008-9520 kit instructions at www.brandmotion.com
HomeLink Set Up and Operation
1. Refer to supplied HomeLink “Programming and Information Guide.”
2. Keep HomeLink “Programming and Information Guide” in vehicle for future reference.
This HomeLink device is approved for use only in the United States and Canada.
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals